Questions about repacking the steering head and swingarm bearings

Bad-mofo · 07-02-2008, 03:01 PM

Since I've never done it and it's due on my R1... How easy it is to do? I suspect it's 100% DIY, meaning no special tools required, but who knows. I'd hate to completely remove the front end or swingarm, not to mention the bike needs to be suspended/supported in some way (the "ladder" method?).

Q1: Can I do it by just loosening the bolts/axles w/o removing anything?
Q2: What kind of grease would you recommend? Compatible with what is there currently (put by the mfr).

ExarKunONe · 07-08-2008, 03:01 PM

A1. This is not too difficult but youll have to take the front and rear end apart. For example you have to take the steering stem/tripple clamps apart. The special tools needed are a torque wrench, spanner wrench, and service manual.

A2. Bell Ray waterproof grease works great. Use a LOT of grease and work it into the bearings.

07-02-2008, 03:01 PM	#1
Bad-mofo Canyon Carver Join Date: Mar 2005 Location: Aliso Viejo, CA Bikes: 03 R6, 04 R1, 06 450SMR Age: 36 Posts: 546 iTrader: (0) Rep Power: 4 (16)	Questions about repacking the steering head and swingarm bearings Since I've never done it and it's due on my R1... How easy it is to do? I suspect it's 100% DIY, meaning no special tools required, but who knows. I'd hate to completely remove the front end or swingarm, not to mention the bike needs to be suspended/supported in some way (the "ladder" method?). Q1: Can I do it by just loosening the bolts/axles w/o removing anything? Q2: What kind of grease would you recommend? Compatible with what is there currently (put by the mfr).

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
FS: Scotts Steering Stabilizer mount kit for GSX-R600 - steering damper	Ofnoan	For Sale	0	07-07-2007 10:03 PM
Car brake pads questions	Bad-mofo	Viper Room	7	07-06-2007 01:30 PM
Far Sale Yamaha R1 Swingarm/tank/tail	HghStrng	For Sale	0	06-11-2007 04:11 AM
swingarm welding	efward	Wrenching/Tech Info & Discussion	3	06-05-2005 10:08 PM
Chain questions ...	Jay fooey	Wrenching/Tech Info & Discussion	19	08-02-2004 06:24 AM

07-08-2008, 03:01 PM	#2
ExarKunONe Newbie Join Date: Jun 2007 Location: Nipomo, CA Bikes: 01 BMW R1100S, 99 R6 Age: 23 Posts: 98 iTrader: (0) Rep Power: 2 (10)	A1. This is not too difficult but youll have to take the front and rear end apart. For example you have to take the steering stem/tripple clamps apart. The special tools needed are a torque wrench, spanner wrench, and service manual. A2. Bell Ray waterproof grease works great. Use a LOT of grease and work it into the bearings.